Resetter Printer Canon G2010 [patched] Jun 2026

While the electronic lock happens automatically, the physical pads might not actually be completely saturated yet. Resetting the digital counter allows you to resume printing immediately, though you should eventually inspect or replace the physical pads to avoid future leaks. Step 1: Entering Service Mode on Canon G2010

No. Resetter tools require low-level USB access to the printer’s EEPROM. Smartphones (iOS/Android) cannot provide this.

If done correctly, the green Power LED will blink for a few moments and then stay lit solidly. The printer's LCD screen will remain entirely blank or black. This signifies that your Canon G2010 is officially in Service Mode and ready to be reset. If the printer screen turns on or shows errors, turn it off and retry the sequence. Step 2: Choosing the Right Resetter Software

It is critical to understand that . It only removes the software lock. If the pad is genuinely saturated, ignoring it could eventually cause ink to leak inside the printer, potentially causing permanent damage. resetter printer canon g2010

Without a resetter, your only official option is to send the printer to an authorized Canon service center. The technician will physically replace the waste ink pads and reset the counter, which can cost between $50 and $100—often more than the printer itself.

Press and hold down the button (the triangle inside a circle).

This error means the software cannot communicate with the printer. It usually happens if the printer is not properly in Service Mode, or if the USB driver hasn't finished loading. Try restarting the printer, entering Service Mode again, and changing the USB port on your PC. Resetter tools require low-level USB access to the

Unplug the USB cable and power cord for roughly 10 seconds to drain residual energy from the capacitors.

Close the Service Tool software. Turn off your printer using its Power button (you may need to press it twice or hold it down for a few seconds). Wait 10 seconds, then turn the printer back on normally.

Follow these steps methodically. Rushing or missing a step can cause the reset to fail. The printer's LCD screen will remain entirely blank or black

Ensure you are using a compatible version of the Service Tool. Using outdated versions (like v3400) on newer G-series models can permanently lock or damage the printer’s mainboard IC chip.

While still holding the Stop/Reset button, press and hold the button.

The Canon Pixma G2010 is a highly reliable ink tank printer, but like all Canon G-series printers, it features a built-in safety counter. After printing thousands of pages, you will eventually encounter a flashing error light accompanied by an or "Ink Absorber Full" message on your computer screen.