Input the motor's exact nameplate Full Load Amps (FLA) for overload protection. Troubleshooting and Fault Codes

: Returns to the previous menu or sets jog control. ⚙️ Common Parameter Settings

Time required to go from 0.0 Hz to 50.00 Hz.

: Configures the frequency source, which can be adjusted via a panel potentiometer, high-speed pulse inputs (1–100 kHz), or analog signals (0–10V or 4–20mA).

The motor is running beyond its rated current capacity for too long.

Always disconnect the main power supply before removing the protective terminal covers.

Connecting input power to U, V, W will instantly destroy the inverter’s output IGBTs. The manual stresses this with a bold warning symbol.

| Parameter | Value | Explanation (from manual) | | :--- | :--- | :--- | | | 0 | 0 = Keypad command (Run/Stop from inverter keys) | | F0.01 | 0 | 0 = Keypad potentiometer for frequency setting | | F1.01 | 380V (or 220V) | Motor rated voltage (from motor nameplate) | | F1.02 | 5.0A | Motor rated current (critical for overload protection) | | F1.03 | 1420 RPM | Motor rated speed | | F2.00 | 5.0 sec | Acceleration time from 0Hz to 50Hz | | F2.01 | 5.0 sec | Deceleration time (increase if overvoltage trips) |

Proper wiring prevents equipment damage and ensures operator safety. Always isolate the main power before touching terminals. Main Circuit Terminals Input power terminals for the 3-phase AC supply.