Close the software, turn off your printer, wait 10 seconds, and turn it back on normally. Your error code should be gone! Troubleshooting Common Errors Error Code 006
The Canon Service Tool v.4718 is a powerful utility for reviving inkjet printers from the 2014–2017 era that have been halted by waste ink errors. For users with an MG3600, MG5700, or G2000/G3000 who are facing error 5B00, this tool is the most reliable solution.
Download and extract the Service Tool v.4718 file (ensure your anti-virus doesn't mistakenly block it). Open the ServiceTool.exe .
Because Canon does not distribute this software publicly to consumers, many download links on the internet contain malware, trojans, or ransomware. Always scan any downloaded .exe files with updated antivirus software before launching them. canon service tool v.4718
This occurs if you don't enter Service Mode correctly, or if your printer model is too new for this version. Try to turn the printer off and enter Service Mode again, a PDF guide suggests.
The is a specialized software utility used by technicians to communicate with the printer in Service Mode. It allows users to reset the internal waste ink counter, perform deep diagnostics, and clear error codes. Understanding the "Ink Absorber Full" Error
Would you like a safer, step-by-step guide to resetting the waste ink counter on your specific Canon model without using this tool? Close the software, turn off your printer, wait
The software is open, but the printer was not booted into Service Mode correctly, or a print job is stuck in the Windows print queue.
In the software, ensure the printer is detected under "USB Port".
Once that counter hits 100%, the printer locks up as a safety measure to prevent ink from leaking onto your desk. Version 4718 is a highly sought-after release because it supports a wide range of older and modern Canon Pixma G, MG, MP, and iP series printers, allowing users to clear the "Waste Ink Pad Full" error independently. Key Features and Capabilities For users with an MG3600, MG5700, or G2000/G3000
Ultimately, the Canon Service Tool v.4718 gives tech-savvy users a fighting chance against planned obsolescence, allowing them to repair rather than replace their printers. Just remember to use it wisely, carefully, and with the proper security precautions in place.
Using a tool that is "too old" (version number too low) for your specific printer will permanently "lock" access to Service Mode, preventing any future resets. For MG3600 users, v.4713 is the minimum, but v.4718 is recommended to avoid lockout. For the newer MG3650S, you may actually need v.5103 instead.